EZ STIK Trowelable Sealant

EZ-STIK Trowelable Sealant

EZ-Stik #3 is a trowelable butyl sealant suitable for pumping or trowel dispensing onto concrete structures.

Document Downloads

Download Product Literature

EZ-STIK’s butyl sealant is primarily used as a backplaster on manhole and box culvert joints and as an external manhole chimney seal. It can be used as a primary or secondary flexible seal that bonds to a wide variety of materials. The physical properties of the sealant resists temperature extremes, acids and alkalis.

How It Works

  • Clean and dry surface.
  • Apply and smooth with a clean edge trowel blade at 1⁄4” minimum thickness.
  • If using in water collection system, do not backfill immediately.

Why It's Better

  • High-quality butyl rubber base.
  • Excellent gap and crack filling properties.
  • Resistance to acids and alkalis.
  • All-weather protection.
  • A permanent flexible solution.

Where To Use

  • Concrete joint repair
  • Sanitary Manhole Joints
  • Stormwater Manhole Joints
  • Irrigation and Drainage Systems
  • Box Culverts
  • Elliptical/Arch Pipe
  • Architectural Foundations
  • Concrete crack repair
  • Underground Utility Vaults
  • Stormwater Treatment & Inlet Structures
  • On-Site Treatment Tanks
  • Grease Interceptors
  • Wet Wells

TROWELABLE EZ-STIK #3 is available in 5 gallon pails or in cartons of 12 – 11 ounce caulking tubes.

Meets or Exceeds

This sealant meets or exceeds:

  • Federal Specification TT-S-001657 for Solvent Release Butyl Sealants

Caution

Must ship via truck freight due to flammability.

INSTALLATION INSTRUCTIONS FOR TROWELABLE #3 EZ-STIK AS A PROTECTIVE COATING

  1. Clean and dry the concrete surface to which the sealant will be applied. Remove any dirt and/or mud adhering to the surface.The surface must be dry for the sealant to adhere and bond to the concrete. #4 EZ Primer can be applied to the surface to increase adhesion of the #3 EZ-STIK
  2. The sealant should be applied with a smooth-edge trowel. Then it should be applied a minimum of 1/4” thick. The surface to be protected must be totally covered with no surface showing through the sealant. Coverage is 7 square feet per gallon when applied 1/4” thick.
  3. When using this sealant as an external chimney seal (Butyl Rubber Backplaster), apply it 6” from below the top cone to the casting. Then it should be applied 1/4” thick with a smooth-edge trowel. After coating the chimney, with the sealant, wrap the applied #3 EZ-STIK with a 6mm polyethylene plastic sheeting by Visqueen or approved equal. Wait 20 minutes before back-filling.
  4. The structure should not be back-filled for a minimum of 20 minutes after coating with the sealant. This allows the solvents to dispense throughout the #3 EZ-STIK.